UMN:CLI User Manual
V5808
648
Serial Number-based ONU Registration
For ONU (ONT) registration, OLT requests a serial number of the connected ONUs
(ONTs) periodically. OLT registers a specific ONU which replies to OLT with its serial
number. The V5808 can allocate ONU-ID to an ONU which sends a valid serial number to
OLT. When ONU with the specific serial number is activated, it is assigned the allocated
ONU-ID.
To register/delete ONU (ONT) automatically by ONU’s serial number acquisition, use the
following command.
discover-serial-number start <1-
1200>
Starts to register ONT by its serial number and
specifies an interval for ONU’s serial number
acquisition.
1-1200: serial number acquisition interval
discover-serial-number stop
Stops discovering ONT using its serial number.
show discover-serial-number
interval [OLT-ID]
Shows the configured interval for requesting ONU’s
serial number.
show discover-serial-number
interval
To remove the serial number of ONU, use the following command.
onu remove serial-number ONU-
ID
Removes the ONU serial number.
ONU-ID: ONU ID (1-128) or ONU serial number
Registration ID-based ONU Registration
A registration ID is assigned to a subscriber at the management level, and provisioned
both into the OLT and communicated to installation or repair personnel or even to the
subscriber directly. The registration ID populates the ONU’s PLOAM password, which is
used by the OLT to recognize the ONU. The OLT may learn the value of the ONU’s serial
number for possible subsequent use in serial number based authentication.
To enter the registration ID into the ONU in the field, use the following command.
onu add ONU-ID registration-id
ID
Adds ONU (ONT) with a specified resgistration ID.
ID: registration ID (PLOAM password)
Logical ONU ID (LOID)-based ONU Registration
The operation of logical ONU ID (LOID) method is similar as registration ID (RID) method
as both the OLT and the ONU agree on a pre-defined logical ID but LOID is more flexible
To Next Page
Loading...