Dasan V5808 - PIM Static Join; Displaying PIM Information

UMN:CLI User Manual
V5808
450
9.3.2.8 PIM Static Join
The IGMP static join feature supports an IGMPv2 host only. PIM static join has been also
developed to reduce the zapping time by statically creating a virtual host that behaves like
a real on a port. However, IGMP static join feature can not be used by Layer 3 device
(Core switch) that is incapable of IGMP feature with no group member (host). In this case,
you can use PIM static join instead of IGMP static join.
To configure the PIM static join, use the following command.
Command
Mode
Description
ip pim static-group A.B.C.D
Interface
Configures the PIM static join.
A.B.C.D: Start/End multicast group
address
ip pim static-group range A.B.C.D A.B.C.D
no ip pim static-group [A.B.C.D | *]
Deletes the configured PIM static join.
*: all addresses
no ip pim static-group range A.B.C.D A.B.C.D
9.3.2.9 Displaying PIM Information
To display current PIM information, use the following command.
Command
Mode
Description
show ip pim interface [detail]
Enable
Global
Bridge
Shows PIM interface information.
detail: includes VIF information
show ip pim local-members
[INTERFACE]
Shows PIM local membership information.
show ip pim mroute A.B.C.D
[A.B.C.D]
Shows the multicast routing table.
A.B.C.D: multicast group or source address
A.B.C.D/M: range of multicast group addresses
static: static multicast route entry
summary: summary of multicast route entry
show ip pim mroute [A.B.C.D/M |
static | summary]
show ip pim nexthop
Shows the next hop information.
A.B.C.D | *: specific or any source address
A.B.C.D: multicast group address
show ip pim nexthop {A.B.C.D |
*} [A.B.C.D]