Dasan V5808 - Displaying T-CONT Information; IP Host Service Configuration; IP Address; Dns

UMN:CLI User Manual
V5808
726
12.4.4.4 Displaying T-CONT Information
To display the information of T-CONT, use the following command.
Command
Mode
Description
show tcont-id OLT-ID [ONU-ID]
Enable
Global
GPON
Shows the information of T-CONT ID of OLT.
show onu tcont OLT-ID
show tcont [ONU-ID]
GPON-OLT
Shows the information of T-CONT allocation for ONU.
show onu detail-info [ONU-ID]
Shows the detailed information (status, serial number,
T-CONT number, T-CONT queue number) of ONU.
show current-profile
All modes
of Traffic-
profile
Shows the information currently configured for the
profile.
12.4.5 IP Host Service Configuration
In order to configure an IP host, you need to create an IP host service ID. To create the IP
host service ID and enter the configuration mode for the host, use the following command.
Command
Mode
Description
ip-host-config SERVICE-ID
Traffic-
Profile
Creates the IP host service ID and enters the
configuration mode for the host.
SERVICE-ID : IP host number (1 to 32)
no ip-host-config SERVICE-ID
Deletes the created IP host service ID.
After opening IP-host Configuration mode, the prompt changes from SWITCH(config-
traffic-pf[NAME])# to SWITCH(config-traffic-pf[NAME]-iphost[ID])#.
12.4.5.1 IP Address
To specify the IP address assignment on the host, use the following command.
Command
Mode
Description
ip address {static | dhcp}
Traffic-
IP-host
Specifies the IP address assignment on the host.
12.4.5.2 DNS
To specify the DNS address assignment on the host, use the following command.
Command
Mode
Description
dns primary A.B.C.D [secondary
A.B.C.D]
Traffic-
IP-host
Specifies the primary/secondary DNS IP address on
the host.