Dasan V5808 - Page 727

User Manual UMN:CLI
V5808
727
ipv6 dns primary X:X::X:X
[secondary X:X::X:X]
Specifies the primary/secondary DNS IPv6 address on
the host.
no dns
Deletes the configured DNS IP address.
no ipv6 dns
Deletes the configured DNS IPv6 address.
12.4.5.3 VLAN Tagging Operating
To configure a VLAN tagging operation on the host, use the following command.
Command
Mode
Description
vlan-operation us-oper keep
Traffic-
IP-host
Sets the policy of VLAN tagging for upstream frame.
keep: keeps forwarding the existing tagged/untagged
frame
vlan-operation us-oper {add |
overwrite} VLAN <0-7>
Sets the policy of VLAN tagging for upstream frame.
add: adds a specified VID (double tagging) with tag in
case of tagged frame
overwrite: replaces an existing tagged/untagged frame
to a specified VID with tag.
VLAN: VLAN ID (1-4094)
0-7: CoS value
vlan-operation ds-oper {keep |
remove}
Sets the policy of VLAN tagging for downstream frame.
keep: keeps forwarding the incoming tagged frame
from OLT to UNI.
remove: removes a tag from the incoming tagged
packet and forwards it to UNI.
no vlan-operation
Deletes the configured policy for VLAN tagging
operation.
12.4.5.4 VLAN Tagging Filtering
If there are more than one mapper connected to VLAN tagging, you need to configure a
VLAN tagging filtering for VLAN ID-based traffic forwarding. To enable/disable VLAN
tagging filtering function on ANI interface, use the following command.
Command
Mode
Description
vlan-filter [vid <1-4094>]
untagged {allow | discard}
Traffic-
IP-host
Enables a VLAN tagging filtering function of ANI-side
port.
allow: forwards the untagged frames to the ANI-side
port
discard: blocks the untagged frames to the ANI-side
port
1-4094: VLAN ID(s)
vlan-filter vid {add | del} VID
Adds or deletes the VLAN ID on the VLAN list
configured by vlan-filter vid command above.
no vlan-filter
Disables the VLAN tagging filtering function.