Dasan V5808 - Disabling Daemon Operation; FTP Bind Address

UMN:CLI User Manual
V5808
116
6.1.11 Disabling Daemon Operation
You can disable the daemon operation unnecessarily occupying CPU. To disable certain
daemon operation, use the following command.
Command
Mode
Description
halt PID
Enable
Disables the daemon operation.
You can display the PID of each running processes with the show process command.
SWITCH# show process
USER PID %CPU %MEM VSZ RSS TTY STAT START TIME COMMAND
admin 1 0.2 0.2 1448 592 ? S Feb23 0:05 init [3]
admin 2 0.0 0.0 0 0 ? S Feb23 0:00 [keventd]
admin 3 0.0 0.0 0 0 ? SN Feb23 0:00 [ksoftirqd_CPU0]
admin 4 0.0 0.0 0 0 ? S Feb23 0:00 [kswapd]
admin 5 0.0 0.0 0 0 ? S Feb23 0:00 [bdflush]
admin 6 0.0 0.0 0 0 ? S Feb23 0:00 [kupdated]
admin 7 0.0 0.0 0 0 ? S Feb23 0:00 [mtdblockd]
admin 8 0.0 0.0 0 0 ? S< Feb23 0:00 [bcmDPC]
admin 9 0.0 0.0 0 0 ? S< Feb23 0:29 [bcmCNTR.0]
admin 16 0.0 0.0 0 0 ? SN Feb23 0:00 [jffs2_gcd_mtd0]
admin 81 0.0 2.0 10524 5492 ? S Feb23 0:53 /usr/sbin/swchd
admin 83 0.0 1.5 6756 3756 ? S Feb23 0:53 /usr/sbin/nsm
(Omitted)
SWITCH#
6.1.12 FTP Bind Address
When used as an FTP client, the V5808 connects to an FTP server via the interface
toward that server, which means the FTP client uses the IP address configured in that
interface as a source IP address. However, an interface of the V5808 may have multiple
IP addresses. In such a multiple-IP environment, a primary IP address is normally used.
You can configure the V5808 to use one of the secondary IP addresses as a source IP of
an FTP client.
To use a specific IP address as a source IP of an FTP client, use the following command.
Command
Mode
Description
ftp bind-address A.B.C.D
Global
Specifies a source IP address of an FTP client.
A.B.C.D: one of the secondary IPv4 addresses
configured in an interface
X:X::X:X: one of the secondary IPv6 addresses
configured in an interface
ftp bind-address X:X::X:X
no ftp bind-address
Deletes a specified source IP address.