UMN:CLI User Manual
V5808
302
priority. It is also possible to configure port priority so that user can configure route
manually. To configure the port-priority, use the following command.
spanning-tree port PORTS port-
priority <0-240>
Configures port priority.
PORTS: port number
0-240: port priority in increments of 16 (default:128)
no spanning-tree port PORTS
port-priority
Deleted a configured port priority.
8.3.5.5 Link Type
A port that operates in full-duplex is assumed to be point-to-point link type, while a half-
duplex is considered as a shared port. .
To configure the link type of port, use the following command.
spanning-tree port PORTS link-
type {point-to-point | shared}
Specifies a link-type for a designated port
PORTS: port number
point-to-point: full-duplex
shared: half-duplex
To delete a configured link type of port, use the following command.
no spanning-tree port PORTS link-type
Deletes a configured link type.
8.3.5.6 Enabling STP configuration on the Port
To enable/disable a STP daemon by applying STP configurations to the port, use the
following command.
spanning-tree port PORTS enable
Enables STP function on the port
spanning-tree port PORTS disable
Disables STP function on the port.
To Next Page
Loading...