Dasan V5808 - Displaying Multicast Information; Multicast Access List; Creating Multicast ACL

User Manual UMN:CLI
V5808
787
Command
Mode
Description
multicast-profile NAME
Traffic
Bridge-UNI
Applies the configured Multicast profile to a specified
UNI port.
NAME: Multicast profile name
no multicast-profile
Deletes the connections between a multicast profile
and this UNI port.
12.11.5 Displaying Multicast Information
To display the information of Multicast profiles, use the following command.
Command
Mode
Description
show multicast-profile
[PROFILE]
GPON
GPON-OLT
Multicast-
Profile
Shows the information of Multicast profiles
PROFILE: Multicast profile name
12.11.6 Multicast Access List
The multicast access list is used for ONU (ONT) to handle the multicast traffic using the
dynamic/static IGMP access list commands. For each dedicated multicast access list, it
can permit/discard the IGMP message and multicast traffic of the specified IP multicast
groups and ranges. It is the responsibility of the OLT to manage the members of a
multicast group and control the multicast connection in ONTs. To implement this multicast
access list per ONT, the specified multicast profile should be already configured on these
ONTs.
12.11.6.1 Creating Multicast ACL
To create a multicast access list, use the following command.
Command
Mode
Description
multicast-access-list NAME
create
GPON
Creates a multicast access list.
NAME: multicast access list name
The maximum number of access list tables can be configurable up to 5 within a multicast
access list.
After opening Multicast Access Control List Configuration mode, the prompt changes from
SWITCH(gpon)# to SWITCH(config-mcast-acl-profile[NAME])#.
To delete a created multicast access list, use the following command.
Command
Mode
Description
no multicast-access-list
{NAME | all}
GPON
Deletes a created multicast access list.
NAME: multicast access list name
i