Dasan V5808 - Displaying Interface; Interface Identifier; Enabling Interface Overlapping

UMN:CLI User Manual
V5808
78
inet 10.27.41.91/24 broadcast 10.27.41.255
input packets 3208070, bytes 198412141, dropped 203750, multicast packets 0
input errors 12, length 0, overrun 0, CRC 0, frame 0, fifo 12, missed 0
output packets 11444, bytes 4192789, dropped 0
output errors 0, aborted 0, carrier 0, fifo 0, heartbeat 0, window 0
collisions 0
SWITCH(config)#
4.3.5 Displaying Interface
To display an interface status and configuration, use the following command.
Command
Mode
Description
show interface [INTERFACE]
Enable
Global
Bridge
Interface
Shows an interface status and configuration.
INTERFACE: interface name
show ip interface {INTERFACE |
brief}
Enable
Global
Bridge
Shows brief information of interface.
INTERFACE: interface name
The following is the sample output of the show ip interface brief command.
SWITCH(config)# show ip interface brief
Interface IP-Address Status Protocol
lo unassigned up up
mgmt 10.27.41.91 up up
default unassigned up up
SWITCH(config)#
4.3.6 Interface Identifier
To specify a identifier on an interface, use the following command.
Command
Mode
Description
identifier hex LINE
Interface
Sets interface identifier.
LINE: Interface identifier of max 8byte value (e.g.
ffeac3c434f20a00)
4.3.7 Enabling Interface Overlapping
To enable/disable the IP address overlapping across multiple interfaces, use the following
command.
Command
Mode
Description