Dasan V5808 - Checking the BGP Network Route; Sending SNMP Trap; Displaying BGP Information

User Manual UMN:CLI
V5808
539
• BGP notification received
• Erroneous BGP update received
• User reset request
• Peer time-out / Peer closing down the session / Member added to peer group
• Interface flap
• Router ID changed
• Neighbor deleted
• Remote AS changed
• Administrative shutdown
11.1.14.4 Checking the BGP Network Route
To check that the BGP network route is reachable through IGP, use the following
command.
Command
Mode
Description
bgp network import-check
Router
Checks BGP network route exists in IGP.
no bgp network import-check
Disables the function.
11.1.14.5 Sending SNMP Trap
To enable/disable the system to send SNMP trap message of BGP routing information,
use the following command.
Command
Mode
Description
bgp snmp-notification enable
Router
Configures the system to send SNMP trap of routing
information while BGP is running.
bgp snmp-notification disable
Disables the system to send SNMP trap of routing
information while BGP is running.
11.1.15 Displaying BGP Information
To display IPv6 BGP protocol information, use the following command.
Command
Mode
Description
show ipv6 protocols bgp
Enable
Global
Shows a current status of BGP protocol and its
information.