Dasan V5808 - Changing Active Firmware; Downloading Firmware to OLT

UMN:CLI User Manual
V5808
678
To display the status of ONU firmware, use the following command.
Command
Mode
Description
show onu firmware version OLT-
ID [ONU-IDs]
Enable
Global
GPON
Shows the status of ONU firmware.
OLT-ID: GPON port number
ONU-ID: ONU ID (1-128) or ONU serial number
show onu firmware version
[ONU-IDs]
GPON-OLT
Shows the status of ONU firmware.
ONU-ID: ONU ID (1-128) or ONU serial number
• Changing Active Firmware
If an ONU supports the dual OS, you can change the active firmware using the following
command. To change the active firmware, use the following command.
Command
Mode
Description
onu firmware active-change
ONU-ID
GPON-OLT
Changes the active OS of ONU (with ONU reboot).
ONU-ID: ONU ID (1 to 128) or ONU serial number
12.2.24.2 Manual Upgrade (2)
(1) Downloading Firmware to OLT
To download ONU (ONT) firmware in the system, use the following command.
Command
Mode
Description
copy {ftp | tftp} onu download
Enable
Downloads ONU firmware via FTP or TFTP.
The following is an example of downloading ONU (ONT) firmware in the system.
SWITCH# copy ftp onu download
To exit : press Ctrl+D
--------------------------------------
IP address or name of remote host (FTP): xxx.xxx.xxx.xxx
Download File Name : XXXXXX.x
User Name : user
Password:
To remove the downloaded ONU (ONT) firmware in OLT, use the following command.
Command
Mode
Description
remove onu firmware FILE-
NAME
Enable
Global
GPON
Removes the downloaded ONU (ONT) firmware in
OLT.