Dasan V5808 - Adding;Applying Traffic Profile; Displaying Traffic Profile Information

UMN:CLI User Manual
V5808
740
12.4.13 Adding/Applying Traffic Profile
If you want to apply a created traffic profile to an ONU profile, open ONU Profile
Configuration mode, where you can add the traffic profile.
SWITCH(config-traffic-pf[AAA])# apply
SWITCH(config-traffic-pf[AAA])# exit
SWITCH(gpon)# onu-profile BB create
SWITCH(config-onu-profile[BB])# traffic-profile AAA
SWITCH(config-onu-profile[BB])# apply
To add/delete the configured traffic profile to a specified ONU profile, use the following
command.
Command
Mode
Description
traffic-profile NAME
ONU-Profile
Adds the configured traffic profile to ONU profile.
NAME: traffic profile name
no traffic-profile
Removes the traffic profile from ONU profile.
You should modify a traffic profile, you should apply the changes again using the apply
command. If you do not, it will not be applied.
12.4.14 Displaying Traffic Profile Information
To display the information of traffic profiles, use the following command.
Command
Mode
Description
show traffic-profile [NAME]
GPON
GPON-OLT
Traffic-
profile
Shows the currently applied configuration information
of traffic profile.
NAME: traffic profile name
show current-profile
Current-
Profile
Shows the information currently configured for the
profile.
To display the information of GEM port ID, use the following command.
Command
Mode
Description
show port-id [ONU-ID]
GPON-OLT
Shows the GEM port ID information.
ONU-ID: ONU ID (1 to 128)
To display the DBA profile associated with the specific Traffic profile, use the following
command.
Command
Mode
Description
show traffic-profile NAME dba-
profile
Enable
Global
GPON
GPON-OLT
Shows the DBA profile associated with the specified
Traffic profile.
NAME: Traffic profile name
i