Dasan V5808 - Displaying ONU Info Registered

User Manual UMN:CLI
V5808
649
because it allows up to 24 characters to store information.
Similarly, ONU is registered first in the OLT with a specific and uniquelogical ID and this
one must be also locally configured to ONU via ONT’s Web UI. The logical ID includes
two parts: an LOID (Logical ONU ID) and a Password.
So the OLT and the network management system based on logical identification of the
ONU authentication should support two kinds of configuration: only LOID and LOID +
Password.
To register ONU automatically by ONU’s serial number acquisition, use the following
command.
Command
Mode
Description
discover-serial-number start <1-
1200>
GPON-OLT
Starts discovering ONT using its serial number.
1-1200: serial number acquisition interval
discover-serial-number stop
Stops discovering ONT using its serial number.
To register ONU by LOID or LOID + PASSWORD mode, use the following command.
Command
Mode
Description
onu add ONU-ID loid LOID
GPON-OLT
Adds ONU with specific LOID
ONU-ID: 1-128
LOID: 1-24 characters
onu add ONU-ID loid LOID
PASSWORD
Add ONU with specific LOID and Password
LOID: 1-24 characters
PASSWORD: 1-12 characters
Also, the LOID and Password must be configured locally in ONT’s Web UI.
To display LOID information of ONU, use the following command.
Command
Mode
Description
show onu loid status [OLT_ID]
Enable
Global
Shows the ONU’s loid information.
show onu loid status [ONU_ID]
GPON-OLT
Displaying ONU Info Registered
To display the registered ONU (ONT) information, use the following command.
Command
Mode
Description
show onu active [OLT-ID]
Enable
Global
GPON
Shows the registered ONU (ONT) information.
OLT-ID: GPON port number
show onu active count [OLT-ID]
Shows the number of active ONUs connected to a
specified GPON port.
show onu active [ONU-ID]
GPON-OLT
Shows the registered ONU information.
i