Dasan V5808 - Rate-Limit Configuration; GPON Optic Module Threshold of ONU

UMN:CLI User Manual
V5808
704
IGMP rate limiting restricts the number of IGMP messages from ONUs within this ONU-
profile. To configure the upstream IGMP rate limit of ONUs, use the following command.
Command
Mode
Description
igmp us-rate-limit <1-65535>
ONU-Profile
Sets the maximum number of upstream IGMP
messages.
1-65535: the number of IGMP messages (unit:
messages per second)
no igmp us-rate-limit
Deletes the configured upstream IGMP rate limit.
12.3.2.8 Rate-limit Configuration
To configure the rate limit for downstream traffic of ONUs, use the following command.
Command
Mode
Description
rate-limit downstream {RATE |
unlimited}
ONU-Profile
Sets the downstream traffic bandwidth for ONU.
RATE: 0 to 2147483584 (in steps of 64Kbps)
no rate-limit downstream
Deletes the configured rate limit
12.3.2.9 GPON Optic Module Threshold of ONU
The ONU’s GPON optic module can operate depending on monitoring type of
temperature, RX/TX power, voltage or Txbias. To set the threshold of GPON optical
transceiver of ONU, use the following command.
Command
Mode
Description
ani-rx-power threshold {low
VALUE [high VALUE] | high
VALUE [low VALUE] }
ONU-Profile
Configures the RX optical power threshold and sends
the configured threshold value to ONUs. The ONUs
monitors the change of values and sends RX power
high/low alarm to OLT when the RX power exceeds the
threshold or it is below the threshold.
VALUE: RX power threshold value ( -127 to 0 dBm)
ani-tx-power threshold {low
VALUE [high VALUE] | high
VALUE [low VALUE] }
Configures the TX optical power threshold and sends
the configured threshold value to ONUs. The ONUs
monitors the change of values and sends TX power
high/low alarm to OLT when the TX power exceeds the
threshold or it is below the threshold.
VALUE: TX power threshold value ( -127 to 0 dBm)
ani-temperature threshold {low
VALUE [high VALUE] | high
VALUE [low VALUE] }
Configures the temperature threshold and sends the
configured threshold value to ONUs. The ONUs
monitors the change of values and sends temperature
high/low alarm to OLT when the temperature exceeds
the threshold or it is below the threshold.
VALUE: temperature threshold value ( -128∼127℃)
ani-tx-bias threshold {low
VALUE [high VALUE] | high
VALUE [low VALUE] }
Configures the txbias threshold and sends the
configured threshold value to ONUs. The ONUs
monitors the change of values and sends txbias
high/low alarm to OLT when the txbias exceeds the
threshold or it is below the threshold.