UMN:CLI User Manual
V5808
538
Shows the summarized network status of BGP
neighboring routers.
show ip bgp [ipv4 {unicast |
multicast}] summary
11.1.14.2 BGP Neighbor
To display the detailed information on BGP neighbor router’s session, use the following
command.
show ip bgp neighbors [NEIGHBOR-IPv4]
Shows general information on BGP
neighbor connections of all neighboring
routers.
show bgp ipv6 neighbors [NEIGHBOR-IPv6]
show ip bgp {unicast | multicast} neighbors
show ip bgp [unicast | multicast] neighbors
NEIGHBOR-IP
Shows information of a specified
neighbor router by its IP address.
NEIGHBOR-IP: neighbor router’ s
IPv4/IPv6 address
show bgp neighbors NEIGHBOR-IP
show ip bgp [unicast | multicast] neighbors
NEIGHBOR-IP advertised-routes
The advertised-routes option displays
all the routes the router has advertised
to the neighbor.
show bgp ipv6 neighbors NEIGHBOR-IPv6
advertised-routes
show ip bgp [unicast | multicast] neighbors
NEIGHBOR-IP received prefix-filter
Displays all received routes from
neighbor router, both accepted and
rejected.
show ip bgp [unicast | multicast] neighbors
NEIGHBOR-IP received-routes
The received-routes option displays all
received routes (both accepted and
rejected) from the specified neighbor. To
implement this feature, BGP soft
reconfiguration is set.
show bgp ipv6 neighbors NEIGHBOR-IPv6
received-routes
show ipv6 bgp neighbors NEIGHBOR-IPv6
received-routes
show ip bgp [unicast | multicast] neighbors
NEIGHBOR-IP routes
The routes option displays the
available routes only that are received
and accepted.
11.1.14.3 Logging Neighbor Changes
To enable/disable logging of status change messages without turning on BGP debugging,
use the following command.
Enables logging of BGP neighbor status changes
no bgp log-neighbor-changes
Disables logging of BGP neighbor status changes
The V5808 logs the following events using the above command.
To Next Page
Loading...