Dasan V5808 - Displaying SNMP Trap

User Manual UMN:CLI
V5808
151
no snmp trap login-failed
no snmp trap dhcp-lease
no snmp trap system-restart
no snmp trap trap-log
no snmp trap-log non-volatile
no snmp trap-log threshold
no snmp trap-source-interface
7.1.12.4 Displaying SNMP Trap
To display the configuration of the SNMP trap, use the following command.
Command
Mode
Description
show snmp trap
Enable
Global
Bridge
Shows the configuration of SNMP trap.
show snmp trap-source-
interface
Shows SNMP trap source interface.
show snmp alarm-report
Shows a collected alarm report based trap.
The following is an example of configuring SNMP trap hosts.
SWITCH(config)# snmp trap-host 10.1.1.1
SWITCH(config)# snmp trap2-host 20.1.1.1
SWITCH(config)# snmp inform-trap-host 30.1.1.1
SWITCH(config)# show snmp trap
snmp trap mode: event
----------------------------
Trap-Host List
Type Host Community
------------------------------------------------
inform-trap-host 30.1.1.1
trap2-host 20.1.1.1
trap-host 10.1.1.1
Trap List
Trap-type Status
--------------------------
auth-fail enable
cold-start enable
cpu-threshold enable
port-threshold enable
dhcp-lease enable
power enable
module enable
fan enable
temp-threshold enable
mem-threshold enable
SWITCH(config)#