Dasan V5808 - Login Password Recovery Process

UMN:CLI User Manual
V5808
58
Command
Mode
Description
passwd [NAME]
Global
Configures a password for created account.
The following is an example of changing the current password.
SWITCH(config)# passwd
Changing password for admin
Enter the new password (minimum of 5, maximum of 8 characters)
Please use a combination of upper and lower case letters and numbers.
Enter new password:junior95
Re-enter new password:junior95
Password changed.
SWITCH(config)#
The password you are entering will not be shown in the screen, so please be careful not
to make a mistake.
4.1.4 Login Password Recovery Process
To recovery login password to default, perform the following step-by-step instruction:
Step 1
After the V5808 is manually restarted, the booting messages are shown up. Keep on
pressing [Space Bar] key right after “[Loading OS1 image ...]” is shown up on the
screen.
Step 2
Enter “password” and press [ENTER] key when the boot process stops for a while next
to “[Image OK : os1]” messages. The current password returns to the default setting
password (no password). You have to set new password for admin.
Step 3
Verify the “password restore to default...” messages.
************************************************************
* *
* Boot Loader Version 6.26 *
* DASAN Networks Inc. *
* *
************************************************************
Press 's' key to go to Boot Mode: 0
[Loading OS1 image ...]
[Image OK : os1]
password
Freeing unused kernel memory: 56520k init
INIT: version 2.85 booting
password restore to default...
Fri, 10 Mar 2000 22:21:35 +0000
!
Step 2
Step1 (Keep on pressing [Space Bar]
Step 3