Dasan V5808 - Configuring Ipv6 Prefix; Interval of RA Messages

UMN:CLI User Manual
V5808
232
To set the other stateful configuration flag in RA message, use the following command.
Command
Mode
Description
ipv6 nd other-config-flag
Interface
Sets the other stateful configuration flag in RA.
no ipv6 nd other-config-flag
Clears the other stateful configuration flag from RA.
(default)
7.16.2 Configuring IPv6 Prefix
To configure how IPv6 prefixes are advertised in the IPv6 RA message, use the following
command.
Command
Mode
Description
ipv6 nd prefix X:X::X:X/M
Interface
Configures how IPv6 prefixes are advertised in the RA
message.
X:X::X:X/M: IPv6 prefix
0-4294967295: valid lifetime
0-4294967295: preferred lifetime
no-autoconfig: specifies prefix cannot be used for IPv6
autoconfiguration.
off-link: specifies prefix to assigned to the link
ipv6 nd prefix X:X::X:X/M <0-
4294967295> <0-4294967295>
[no-autoconfig | off-link]
no ipv6 nd prefix X:X::X:X/M
Deletes a configured how IPv6 prefixes are advertised
in the RA message.
To configure existing IPv6 address on interface as ND prefix in the IPv6 RA message, use
the following command.
Command
Mode
Description
ipv6 nd prefix default
Interface
Configures the existing IPv6 address assigned on an
interface as ND prefix.
ipv6 nd prefix default <0-
4294967295> <0-4294967295>
[no-autoconfig | off-link]
Configures the existing IPv6 address assigned on an
interface as ND prefix and sets its parameters.
no ipv6 nd prefix default
Clears a configured ND prefix using the existing IPv6
address of interface
7.16.3 Interval of RA Messages
To prevent synchronization with other IPv6 nodes, the actual value used should be
randomly adjusted to within plus or minus 20 percent of the specified value. To configure
the interval between IPv6 Router Advertisement transmissions from this interface, use the
following command.
Command
Mode
Description
ipv6 nd ra-interval <3-1800> [<3-
1350>]
Interface
Specifies the interval between IPv6 RA messages.
(default: 600 seconds)