Dasan V5808 - ONU Threshold

UMN:CLI User Manual
V5808
702
The ONU periodically sends the loop-detecting packet to all the ports with a certain
interval, and then if the loop-detecting packet is received, the switch performs a pre-
defined behavior.
To enable/disable the loop detection, use the following command.
Command
Mode
Description
loop-detect {enable | disable}
ONU-Profile
Enables/disables the loop detection.
To define the behavior when a loop is occurred, use the following command.
Command
Mode
Description
loop-detect block
ONU-Profile
Enables the blocking option. This configures to
automatically change the state to BLOCKED when a
loop is detected. (default: disable)
loop-detect block block-timer
{<1-65535> | unlimited}
Sets the interval of changing the state of BLOCKED to
NORMAL.
1-65535: interval (unit: second, default: 600)
unlimited: do not change the state
no loop-detect block
Disables the blocking option.
To set the interval of sending the loop-detecting packet, use the following command.
Command
Mode
Description
loop-detect send-period <1-
65535>
ONU-Profile
Sets the interval of sending the loop-detecting packet.
1-65535: interval (unit: second)
12.3.2.5 ONU Threshold
To set the threshold of ONU CPU load, use the following command.
Command
Mode
Description
cpu-load threshold <0-100>
ONU-Profile
Sets the threshold of CPU load in the unit of percent
(%).
0-100: ONU CPU load threshold value
no cpu-load threshold
Deletes the configured threshold of CPU load.
To set the threshold of ONU temperature, use the following command.
Command
Mode
Description
temperature high-threshold <-
40-100>
ONU-Profile
Sets the threshold of ONU temperature in the unit of
centigrade (°C).
-40-100: ONU temperature
temperature low-threshold <-40-
100>
no temperature { high-threshold
| low-threshold }
Deletes a configured threshold of ONU temperature.