Dasan V5808 User Manual

UMN:CLI User Manual
V5808
544
no ip ospf message-digest-key
<1-255>
no ip ospf A.B.C.D message-
digest-key <1-255>
11.2.4.3 Interface Cost
OSPF protocol assigns suitable cost according to the bandwidth on the each interface to
find the shortest route. Cost is used for packet routing, and routers are using the Cost to
communicate.
To configure an interface cost for OSPF, use the following command.
Command
Mode
Description
ip ospf cost <1-65535>
Interface
Configures an interface cost for OSPF.
ip ospf A.B.C.D cost <1-65535>
To delete a configured interface cost for OSPF, use the following command.
Command
Mode
Description
no ip ospf cost
Interface
Deletes a configured an interface cost for OSPF.
no ip ospf A.B.C.D cost
11.2.4.4 Blocking Transmission of Route Information Database
OSPF routing communicates through the LAS. Each routing information is saved internal
router as a datebase, but user can configure the specific interface to block the
transmission of routing information saved in database to other router.
To block the transmission of routing information to other router, use the following
command.
Command
Mode
Description
ip ospf database-filter all out
Interface
Blocks the transmission of routing information to other
router.
ip ospf A.B.C.D database-filter
all out
To release a blocked interface, use the following command.
Command
Mode
Description
no ip ospf database-filter
Interface
Releases a blocked interface.
no ip ospf A.B.C.D database-
filter
11.2.4.5 Routing Protocol Interval
Routers on OSPF network exchange various packets, about that packet transmission,

Dasan V5808 Specifications

General

Brand	Dasan
Model	V5808
Category	Network Router
Language	English