Dasan V5808 User Manual

User Manual UMN:CLI
V5808
543
11.2.4.2 Authentication Key
If authentication enables on OSPF router interface, the password is needed for
authentication. The authentication key works as a password. The authentication key must
be consistent across all routers in an attached network.
There are two ways of authentication by user selection, one is type based on text, and
another is MD5 type.
The authentication key must be consistent across all routers in an attached network.
To configure an authentication key which is based on text encoding, use the following
command.
Command
Mode
Description
ip ospf authentication-key KEY
Interface
Configures the authentication which is based on text
encoding.
KEY: maximum 16 alphanumeric characters
ip ospf authentication-key KEY
{first | second} [active]
ip ospf A.B.C.D authentication-
key KEY
ip ospf A.B.C.D authentication-
key KEY {first | second} [active]
To configure an authentication key which is based on MD5 encoding, use the following
command.
Command
Mode
Description
ip ospf message-digest-key <1-
255> md5 KEY [active]
Interface
Configures the authentication which is based on md5
type.
1-255: key ID
KEY: maximum 16 alphanumeric characters
ip ospf message-digest-key <1-
255> md5 [active]
ip ospf A.B.C.D message-digest-
key <1-255> md5 KEY [active]
ip ospf A.B.C.D message-digest-
key <1-255> md5 [active]
To delete a configured authentication key, use the following command.
Command
Mode
Description
no ip ospf authentication-key
Interface
Deletes a configured authentication key.
no ip ospf authentication-key
{first | second}
no ip ospf A.B.C.D
authentication-key
no ip ospf A.B.C.D authentica-
tion-key {first | second}
!

Dasan V5808 Specifications

General

Brand	Dasan
Model	V5808
Category	Network Router
Language	English