Dasan V5808 - Retry Count for Auto Upgrade; Configuration of ONU Restart; Enabling Auto Upgrade (on GPON-OLT Configuration Mode)

User Manual UMN:CLI
V5808
683
To see the ONU model name, use show onu model-name command. (See 12.2.25
Displaying ONU Information)
• Retry Count for Auto Upgrade
The retry count argument specifies how many times to retry the auto upgrading of ONU if
the first attempt fails. To specify the retry count of auto upgrade, use the following
command.
Command
Mode
Description
onu auto-upgrade retry-count
<3-10>
GPON
Specifies the retry count of auto upgrade.
3-10 : retry count (default: 3)
no onu auto-upgrade retry-
count
Deletes the configured retry count.
(4) Configuration of ONU Restart
To use the upgraded ONU firmware, the ONU must restart.
You can configure the upgrade-completed ONU to restart at specified time. To specify the
time that the upgrade-completed ONU restarts, use the following command.
Command
Mode
Description
onu auto-upgrade reboot-time [NAME] {<0-
23> | immediately}
GPON
Specifies the time that the upgrade-
completed ONU restarts.
NAME: ONU model name
0-23: restart time (unit: o’clock)
onu auto-upgrade reboot-time [NAME]
disable
Deletes the specified time.
(5) Enabling Auto Upgrade (on GPON-OLT Configuration mode)
To enable/disable ONU auto upgrade on the specific OLT port, use the following
command.
Command
Mode
Description
onu auto-upgrade {enable |
disable} [ONU_ID]
GPON-OLT
Enables/disables ONU auto upgrade configuration on
the OLT port.
In order to apply the auto upgrade for ONU, you should enable the configured auto
upgrade on the specific OLT port by onu auto-upgrade enable command on GPON-OLT
Configuration mode.
i
i