Dasan V5808 - OLT Management; Opening OLT Mode

User Manual UMN:CLI
V5808
627
The following shows the main commands of GPON Configuration mode.
SWITCH(config)# gpon
SWITCH(gpon)# ?
GPON configuration commands:
clear Reset functions
dba-profile Configure GPON DBA Profile
debug Debugging functions
do To run exec commands in config mode
exit End current mode and down to previous mode
extended-vlan-tagging-operation Configure Extended Vlan Tagging Operation
(ME:171)
gpon-olt Configure GPON-OLT
help Description of the interactive help system
multicast-profile Configure Multicast Operation Profile
(ME:309)
no Negate a command or set its defaults
olt OLT configuration
onu ONU configuration
onu-profile Configure GPON Profile
pm-profile Configure GPON Performance Monitor Profile
pw-maintenance-profile Configure GPON PW Maintenance Private Profile
remove Remove file
show Show running system information
tdm-pw-profile Configure GPON TDM PW Private Profile
traffic-profile Configure GPON Traffic Profile
voip-profile Configure VoIP Private Profile
write Write running configuration to memory or
terminal
SWITCH(gpon)#
To open GPON Configuration mode, use the following command.
Command
Mode
Description
gpon
Global
Opens GPON Configuration mode.
12.1 OLT Management
This section describes how to manage an OLT. The OLT is managed in GPON-OLT
Configuration mode.
12.1.1 Opening OLT Mode
To open GPON-OLT Configuration mode and enable an OLT, use the following command.
Command
Mode
Description
gpon-olt OLT-ID
GPON
GPON-OLT
Opens GPON-OLT Configuration mode.
OLT-ID: GPON port number (e.g. 1, 2, 3, 4)