Dasan V5808 - Bridge Configuration Mode; Main Command of Global Configuration Mode

UMN:CLI User Manual
V5808
42
Command
Description
access-list
Configures an access list.
bridge
Opens Bridge Configuration mode.
dns
Sets a DNS server.
dot1x
Configures 802.1X authentication.
exec-timeout
Sets an auto log-out timer.
help
Shows a description of the interactive help system.
hostname
Sets a host name of the system.
interface
Opens Interface Configuration mode to configure a specified interface.
mvr
Configures MVR.
ntp
Configures NTP.
passwd
Sets a system password.
qos
Configures QoS.
rmon-alarm
Opens RMON Configuration mode to configure RMON alarm.
route-map
Opens Route-map Configuration mode.
snmp
Configures SNMP.
ssh
Configures SSH.
syslog
Configures a syslog.
threshold
Sets a system threshold.
Tab. 3.3 Main Command of Global Configuration Mode
3.1.4 Bridge Configuration Mode
In Bridge Configuration mode, you can configure various Layer 2 functions such as VLAN,
STP, LACP, etc.
To open Bridge Configuration mode, enter the bridge command, then the system prompt
will be changed from SWITCH(config)# to SWITCH(bridge)#.
Command
Mode
Description
bridge
Global
Opens Bridge Configuration mode.
Tab. 3.4 shows main commands of Bridge Configuration mode.
Command
Description
lacp
Configures LACP.
mac
Configures a MAC table.
mirror
Configures a port mirroring.
port
Configures Ethernet port.
trunk
Configures a trunk port.
vlan
Configures VLAN.
Tab. 3.4 Main Command of Bridge Configuration Mode