Dasan V5808 - FTP Upgrade

User Manual UMN:CLI
V5808
805
Step 4 Reboot the system with the new system software using the following command.
Command
Mode
Description
reboot [os1 | os2]
Boot
Reboots the system with specified system software.
os1 | os2: the area where the system software is stored
If the new system software is a current standby OS, just exit the boot mode, then the
interrupted system boot will be continued again with the new system software.
To exit the boot mode, use the following command.
Command
Mode
Description
exit
Boot
Exits the boot mode.
14.3 FTP Upgrade
The system software of the can be upgraded using FTP. This will allow network or
system administrators to remotely upgrade the system with the familiar interface.
To upgrade the system software using FTP, perform the following step-by-step instruction:
Step 1 Connect to the with your FTP client software. To login the system, you can use the
system user ID and password.
Note that you must use the command line-based interface FTP client software when
upgrading the . If you use the graphic-based interface FTP client software, the system
cannot recognize the upgraded software.
Step 2 Set the file transfer mode to the binary mode using the following command.
Command
Mode
Description
bin
FTP
Sets the file transfer mode to the binary mode.
Step 3 Enable to print out the hash marks as transferring a file using the following command.
Command
Mode
Description
hash
FTP
Prints out the hash marks as transferring a file.
Step 4 Uploads the new system software using the following command.
Command
Mode
Description
put FILENAME {os1 | os2}
FTP
Uploads the system software.
FILENAME: system software file name
os1 | os2: the area where the system software is stored
!