User Manual UMN:CLI
V5808
199
To delete a specified rule action(no-action match), use the following command.
Deletes a specified rule action.
no no-action match permit
7.5.7.4 Applying and Modifying Admin Policy
After configuring an admin policy using the above commands, apply it to the system with
the following command. If you do not apply this policy to the system, all specified
configurations from Admin-Policy Configuration mode will be lost.
To save and apply an admin policy, use the following command.
Applies an admin policy to the system.
To modify an admin policy, use the following command.
Modifies an admin policy.
NAME: admin-policy name.
7.5.8 Displaying Admin Rule
To show an admin rule profile configured by user, use the follwing command.
Shows a profile of admin flow.
show policy-profile admin
Shows a profile of admin policy.
The following command can be used to show a certain rule by its name, all rules of a
certain type, or all rules at once sorted by a rule type.
show { flow | class | policy }
admin [NAME]
Shows the information relating to each rule, enter an
admin rule name.
show { flow | class | policy }
admin detail [NAME]
show running-config { admin-
flow | admin-policy }
Shows all configurations of admin rules.
To Next Page
Loading...