Dasan V5808 - Clearing MRIB Entry

UMN:CLI User Manual
V5808
484
[THRESHOLD]
routing entries.
LIMIT: number of routing entries (1-214783647)
THRESHOLD: warning threshold (1-214783647)
no ipv6 multicast route-limit
Deletes a specified limit.
The warning threshold must not exceed the maximum number of multicast routing entries.
10.3.1.4 Displaying MRIB Entry
To display the multicast routing entries in the MRIB, use the following command.
Command
Mode
Description
show ipv6 mroute [summary |
count]
Enable
Global
Shows all multicast routing entries.
summary: abbreviated display
count: route and packet count data
show ipv6 mroute [dense |
sparse] [count | summary]
Shows the multicast routing entries for a given PIM
mode.
dense: dense mode
sparse: sparse mode
count: route and packet count data
summary: abbreviated display
show ipv6 mroute X:X::X:X
[dense | sparse] [count
[summary]
Shows the multicast routing entries for a given group.
X:X::X:X: IPv6 source/group address
show ipv6 mroute X:X::X:X
X:X::X:X [dense | sparse] [count |
summary ]
Shows the multicast routing entries for a given group
and source.
X:X::X:X: IPv6 source/group address
If you use the clear ipv6 mroute command, the MRIB clears the multicast routing entries
in its multicast routing table, and removes the entries from the multicast forwarder.
10.3.1.5 Clearing MRIB Entry
To delete the multicast routing entries in the MRIB, use the following command.
Command
Mode
Description
clear ipv6 mroute *
Enable
Global
Deletes all multicast route entries.
clear ipv6 mroute X:X::X:X
[X:X::X:X]
Deletes a specified multicast route entry.
X:X::X:X: IPv6 source/group address
To clear the multicast forwarding cache (MFC) and tree information base (TIB) entries in
the PIM-SM protocol level, use the following command.
Command
Mode
Description
!