User Manual UMN:CLI
V5808
561
• default-information originate metric-type <1-2> always
• default-information originate route-map MAP-NAME metric <0-16777214>
To delete the configuration, use the following command.
no default-information originate
Deletes the configuration.
no default-information originate
metric <0-16777214>
no default-information originate
metric-type <1-2>
no default-information originate
always
no default-information originate
route-map MAP-NAME
11.2.11 ECMP Route Hashing
Equal-Cost Multi-Path (ECMP) is a forwarding mechanism that routes packets along
multiple paths of equal cost. ECMP provides equally-distributed link load sharing across
the paths. The hashing algorithm used is based on the source IP address (SIP) or both
source and destination IP address (SIP-DIP). ECMP routes allow the switch to choose
between several next hops toward a given destination.
When a dynamic route is added through Open Shortest Path First (OSPF), the switch
checks the route's gateway against the ECMP static routes. If the gateway matches one
of the single or ECMP static route destinations, then the OSPF route is added to the list of
ECMP static routes. Traffic is load-balanced across all of the available gateways. When
the OSPF dynamic route times out, it is deleted from the list of ECMP static routes.
To perform ECMP route hashing, use the following command.
ip ecmp-hash {sip | sip-dip}
[l4port]
Enables ECMP hashing algorithm based on IP
address.
sip: source IP address (default)
sip-dip: source and destination IP address
l4port: layer4 port
11.2.12 Finding Period
OSFP start to find the shortest path as soon as got a notification of changing the network
component. You can configure the period to find the path. To configure the period of
finding, use the following command.
timers spf SPF-DELAY SPF-
HOLD
Configures the period of finding in the unit of second.
SPF-DELAY: 0-4294967295 (default: 5)
SPF-HOLD: 0-4294967295 (default: 10)
To Next Page
Loading...