Dasan V5808 - Displaying Configuration; Configuring MSTP

User Manual UMN:CLI
V5808
303
8.3.5.7 Displaying Configuration
To display the configurations of STP, use the following command.
Command
Mode
Description
show spanning-tree
Enable
Global
Bridge
Shows all configurations of STP
show spanning-tree active [detail]
Bridge
Shows STP information on active
interface:
detail: detailed STP information (as
option).
show spanning-tree blockedport
Shows information of the blocked ports
show spanning-tree detail [active]
Shows detailed information of STP.
show spanning-tree inconsistentports
Shows information of root-inconsistency
state.
show spanning-tree bridge [ address | detail |
forward-time | hello-time | id | max-age |
protocol | priority [system-id] ]
Shows information of the bridge status
and configuration
show spanning-tree root [ address | cost |
detail | forward-time | hello-time | id | max-age |
port | priority [system-id] ]
Shows the status and configuration for
the root bridge.
show spanning-tree port PORTS [ active
[detail] | cost | detail [active] | edgeport |
inconsistency | rootcost | state | priority ]
Shows STP information of specified
port.
show spanning-tree summary [totals]
Shows a summary of STP:
totals: the total lines of STP
8.3.6 Configuring MSTP
To configure MSTP, use the following steps.
Step 1
Enable STP function using the spanning-tree command.
Step 2
Select a MSTP mode using the spanning-tree mode mst command.
Step 3
Configure detail options if specific commands are required.
Step 4
Enable a MSTP daemon using the spanning-tree mst command.