User Manual UMN:CLI
V5808
569
overflow database
<1-4294967294> [hard | soft]
Assigns the number of LSA for internal route.
overflow database external
<0-2147483647> <0-65535>
Assigns the number of LSA for external route.
When there is an overflow, hard configuration will stop the process, and soft
configuration will send a caution message.
To release the configuration, use the following command.
Releases the configuration for OSPF internal route.
no overflow database external
[<0-2147483647>]
Releases the configuration for OSPF external route.
no overflow database external
<0-2147483647> [<0-65535>]
11.2.20 OSPF Debug
To enable OSPF debugging, use the following command.
debug ospf events [abr | asbr |
lsa | nssa | os | router | vlink]
Enables debugging about OSPF operation such as
OSPF neighbor router, transmitted information,
deciding destination router, calculating the shortest
route, and so on.
debug ospf ifsm [events | status
| timers]
Enables debugging about OSPF interface.
debug ospf lsa [flooding |
generate | install | maxage |
refresh]
Enables debugging about information transmitted by
OSPF and calculating the shortest route.
debug ospf nfsm [events | status
| timers]
Enables debugging about OSPF Neighbor router.
debug ospf nsm [interface |
redistribute]
Enables debugging between OSPF process and NSM
(Network Services Module).
debug ospf packet [hello | dd |
ls-ack | ls-request | ls-update |
send | recv | detail]
Enables debugging about each packet.
debug ospf route [ase | ia |
install | spf]
Enables debugging about OSPF routing.
To disable OSPF debugging, use the following command.
To Next Page
Loading...