UMN:CLI User Manual
V5808
682
---------------------------------------------------------------------------------
G_ONU_DALLAS_22_0_8_33.bin | TFTP | 10.55.2.4 | XXX | XXXX
To specify the execution condition of ONU auto upgrade configuration above, you should
specify a target version of ONU firmware with (or without) exclude option. Through the
target version and the option, auto upgrade execution condition is determined.
To set the target version for ONU, use the following command.
onu auto-upgrade target-version
NAME VERSION [exclude]
Sets the target version for ONU.
NAME: ONU model name
VERSION: target version
no onu auto-upgrade target-
version NAME
Deletes the configured target version for ONU.
If exclude option is used, the auto-upgrade is performed only when the ONU’s existing
firmware version is different from the specified target version. Otherwise, if exclude
option is not used, the auto-upgrade is performed only when the ONU’s existing firmware
version is same as the specified target version.
To display the target version configuration for ONU auto upgrade, use the following
command.
show onu auto-upgrade target-
version
Shows the target version configuration for ONU auto
upgrade.
(3) Specifying Time and Retry Count
• Specifying Time for Auto Upgrade
You should set the clock of switch to start auto upgrade of ONU (download to ONU) at
specified time. To specify the time to start auto upgrade of ONU, use the following
command.
onu auto-upgrade model-name NAME start-
time <0-23> end-time <0-23>
Specifies the time to start auto upgrade of
ONU.
NAME: ONU model name
0-23: start/end time (unit: o’clock)
onu auto-upgrade model-name NAME start-
time disable
Deletes the specified time.
no onu auto-upgrade model-name NAME
start-time
To Next Page
Loading...