Dasan V5808 - Maximum and Minimum Bandwidth; DSCP-To-Cos Mapping

User Manual UMN:CLI
V5808
203
7.5.9.3 Maximum and Minimum Bandwidth
To set a maximum bandwidth, use the following command.
Command
Mode
Description
qos max-bandwidth PORTS <0-
7> {BANDWIDTH | unlimited}
Global
Sets a maximum bandwidth for each port and queue:
PORTS: port numbers
0-7: queue number
BANDWIDTH: bandwidth in the unit of MB
unlimited: unlimited bandwidth
To set a maximum bandwidth, use the following command.
Command
Mode
Description
qos min-bandwidth PORTS <0-
7> {BANDWIDTH | unlimited}
Global
Sets a minimum bandwidth for each port and queue:
PORTS: port numbers
0-7: queue number
BANDWIDTH: bandwidth in the unit of MB (default: 0)
unlimited: unlimited bandwidth
A maximum/minimum bandwidth can be set only in DRR scheduling mode.
7.5.9.4 DSCP-to-CoS Mapping
To configure DSCP-to-CoS mapping function for guranting DSCP-based QoS and
marking the packet as the color, use the following command.
Command
Mode
Description
qos map dscp <0-63> newdscp
<0-63> cos <0-7> cng {green|
yellow| red}
Global
Sets the DSCP-to-CoS mapping with the color
marking.
no qos map dscp <0-63>
Restores its DSCP-to-CoS mapping configuration to
the default.
To display the DSCP-to-CoS configuration, use the following command.
Command
Mode
Description
show qos map dscp [<0-63>]
Enable
Global
Bridge
Shows the DSCP-to-CoS configuration.
To determine the 802.1p priority of incoming packets through a port using dscp-to-cos
mapping table, use the following command.
!