Dasan V5808 - Ipv6 Prefix Lists

UMN:CLI User Manual
V5808
504
10.3.9.2 Static SSM Mapping
The purpose of static SSM mapping is to provide SSM service only for MLDv1 and
MLDv2 report messages. It means that a multicast host can receive multicast traffic from
the specified group and you can set the source which this traffic is expected from. You
can specify a source address of multicast server to receive the multicast traffic from
specified sources.
If this system receives MLDv1 report message from the host when static SSM mapping is
enabled, it handles as if it receives MLDv2 report messages.
Static SSM mapping implemented for the V5808 has the following restriction, so you must
keep it in mind, before configuring static SSM mapping.
MLD proxy and static SSM mapping cannot be enabled together. It means that SSM
mapping cannot be enabled when the system is already configured with upstream or
downstream interface with MLD proxy feature.
Before configuring static SSM mapping, you should first globally enable SSM mapping.
To enable static SSM mapping, use the following command.
Command
Mode
Description
ipv6 mld ssm-map enable
Global
Enables SSM mapping for groups in a configured SSM
range.
no ipv6 mld ssm-map enable
Disables SSM mapping for groups.
To specify the Source IPv6 address for static SSM mapping, depending on the specified
ACL, use the following command.
Command
Mode
Description
ipv6 mld ssm-map static WORD
X:X::X:X
Global
Enables a static SSM mapping for the MLDv1 group
that matches specified ACL and IPv6 source address.
WORD: IPv6 standard access list (<1-99>)
X:X::X:X: source address to use for static map group
no ipv6 mld ssm-map static
WORD X:X::X:X
Disables a static SSM mapping for the MLDv1 group
that matches specified ACL and IPv6 source address.
To display information about configured SSM mapping, use the following command.
Command
Mode
Description
show ipv6 mld ssm-map
[X:X::X:X]
Enable
Global
Shows a static SSM mapping information
X:X::X:X: IPv6 multicast group address
10.3.10 IPv6 Prefix Lists
Filtering through prefix list processes routing information in specific order by applying
policy defined in filter list. It is similar to access list but there are more detail rules as
!