User Manual UMN:CLI
V5808
541
clear ip ospf [<0-65535>]
process
Restart the OSPF process
0-65535: process ID number
If there is changing router ID while OSPF process is operating, configuration must be
processed from the first. In this case, the V5808 can change only router ID without
changing related configurations.
Changes only a router ID without changing related
configurations.
no ospf router-id A.B.C.D
Deletes a changed router ID.
To transfer above configuration to other routers, Use the clear ip ospf process
command to restart OSPF process.
Step 3
Use the network command to specify a network to operate with OSPF.
There are two ways to show network information configurations. Firstly, shows IP address
with bitmask like “10.0.0.0/8”. Secondly, shows IP address with wildcard bit information
like “10.0.0.0 0.0.0.255”. The variable option after area must be IP address or OSPF area
ID.
To configure a network, use the following command.
network A.B.C.D/M area {<0-
4294967295> | A.B.C.D}
Specifies a network with OSPF area ID.
0-4294967295: OSPF area ID
network A.B.C.D A.B.C.D area
{<0-4294967295> | A.B.C.D}
11.2.2 ABR Type Configuration
The V5808 supports 4 types of OSPF ABR which are Cisco type ABR (RFC 3509), IBM
type ABR (RFC 3509), IETF Draft type and RFC 2328 type.
To configure ABR type of OSPF, use the following command.
ospf abr-type {cisco | ibm |
shortcut | standard}
Selects an ABR type.
cisco: cisco type ABR, RFC 3509 (default)
ibm: IBM type ABR, RFC 3509
shortcut: IETF draft type
standard: RFC 2328 type
To Next Page
Loading...