Dasan V5808 - Assigning IP Address of SNMP Agent; SNMP Com2 Sec

UMN:CLI User Manual
V5808
142
Bridge
7.1.4 Assigning IP Address of SNMP Agent
If SNMP agent has several IP addresses, SNMP carries the information through the best
suited path (IP address) when SNMP administrator requests for information. It means that
SNMP administrator can be received the information from a different IP address which
was not actually a given IP address before. To assign IP address of SNMP agent, use the
following command.
Command
Mode
Description
snmp agent-address A.B.C.D
Global
Assigns an IP address of SNMP agent.
no snmp agent-address
Deletes the configured IP address of
SNMP agent
To display IP address of SNMP agent, use the following command.
Command
Mode
Description
show snmp agent-address
Enable/Global/Bridge
Shows an IP address of SNMP agent.
7.1.5 SNMP Com2sec
SNMP v2 authorizes the host to access the agent according to the identity of the host and
community name. The com2sec command specifies the mapping from the identity of the
host and community name to security name.
To configure an SNMP security name, use the following command.
Command
Mode
Description
snmp com2sec SECURITY
{IP-ADDRESS | IP-ADDRESS/M}
COMMUNITY
Global
Specifies the mapping from the identity of the host and
community name to security name, enter security and
community name.
SECURITY: security name
COMMUNITY: community name
no snmp com2sec SECURITY
Deletes a specified security name, enter the security
name.
SECURITY: security name
show snmp com2sec
Enable
Global
Bridge
Shows a specified security name.
The following is an example of configuring SNMP com2sec.
SWITCH(config)# snmp com2sec TEST 10.1.1.1 PUBLIC
SWITCH(config)# show snmp com2sec
Com2Sec List
SecName Source Community
------------------------------------------------