Dasan V5808 - Syslog Bind Address; Debug Message for Remote Terminal; Disabling Syslog; Syslog Local Message Configuration

UMN:CLI User Manual
V5808
172
SWITCH(config)# syslog output err remote 10.1.1.1
SWITCH(config)# syslog local-code 0
SWITCH(config)# show syslog
System logger on running!
info local volatile
info local non-volatile
err remote 10.1.1.1
local_code 0
SWITCH(config)#
7.4.3 Syslog Bind Address
You can specify an IP address to attach to the syslog message for its identity. To specify
the IP address to bind to a syslog message, use the following command.
Command
Mode
Description
syslog bind-address {A.B.C.D |
X:X::X:X}
Global
Specifies the IP address to bind to a syslog message.
no syslog bind-address
Deletes a specified IP address.
7.4.4 Debug Message for Remote Terminal
To display a syslog debug message to a remote terminal, use the following command.
Command
Mode
Description
terminal monitor
Enable
Enables the terminal monitor function.
no terminal monitor
Disables the terminal monitor function.
This function is not operational in the local console.
7.4.5 Disabling Syslog
To disable the syslog, use the following command.
Command
Mode
Description
no syslog
Global
Disables the syslog.
The syslog is enabled by default.
7.4.6 Syslog Local Message Configuration
To configure the volatile size of syslog message, use the following command.
Command
Mode
Description
i
i