User Manual UMN:CLI
V5808
393
To display current incoming packet statistics and configurations for PPS control, use the
following command.
show pps-control port [PORTS]
Shows current incoming packet statistics and
configurations for PPS control.
8.11 Storm Control
The V5808 provides a storm control feature for mass broadcast, multicast, and
destination lookup failure (DLF). Generally, wrong network configuration, hardware
malfunction, virus and so on cause these kinds of mass packets. Packet storm occupies
most of the bandwidth of the network, and that causes the network to become very
unstable.
To enable/disable the storm control, use the following command.
storm-control {broadcast |
multicast | dlf} RATE [PORTS]
Enables broadcast, multicast or DLF storm control
respectively in a port with a user defined rate.
RATE: unit: Packet/s, range: FE(0-262142), GE(0-
2097150)
no storm-control {broadcast |
multicast | dlf} [PORTS]
Disables broadcast, multicast or DLF storm control
respectively.
By default, DLF storm control is enabled and multicast storm control is disabled.
To display a configuration of the storm control, use the following command.
Displays a configuration of the storm control.
8.12 Jumbo Frame Capacity
The packet range that can be capable to accept is from 64 bytes to 1518 bytes. Therefore,
packets not between these ranges will not be taken. However, the V5808 can accept
To Next Page
Loading...