Dasan V5808 - OLT Description; Activating OLT; Downstream Encryption

UMN:CLI User Manual
V5808
628
12.1.1.1 OLT Description
To specify or modify a description of an OLT, use the following command.
Command
Mode
Description
olt description DESCRIPTION
GPON-OLT
Registers the OLT’s description.
no olt description
Deletes the description of OLT.
To display a description of an OLT, use the following command.
Command
Mode
Description
show olt description [OLT_ID]
Enable/Global/GPON
Shows the OLT’s description.
show olt description
GPON-OLT
12.1.1.2 Activating OLT
To activate/deactivate an OLT, use the following command.
Command
Mode
Description
olt activate
GPON-OLT
Activates a specified OLT.
olt deactivate
Deactivates a specified OLT.
12.1.2 Downstream Encryption
Encryption of downstream data is automatic process performed by OLT for specified
ONU-IDs configured as encrypted. GPON OLT uses encryption key of the ONU (ONT)
associated with encrypted OLT-ID. To synchronize encryption and decryption keys
between OLT and ONU (ONT), you have to activate the key exchange process. For
security reasons, GPON standard requires periodic key exchange for all active ONUs
(ONTs) that use downstream data traffic. Encryption of downstream data uses AES
algorithm with a key generated by each ONU (ONT) and configured by GPON OLT. To
enable/disable the encryption mode of downstream traffic, use the following command.
Command
Mode
Description
onu encryption ONU-ID enable
GPON-OLT
Enables the encryption mode.
ONU-ID: ONU ID (1 to 128) or ONU serial number
onu encryption ONU-ID disable
Disables the encryption mode.
To start/stop an encryption key exchange process between OLT and ONU (ONT) and
specify an interval of key exchange, use the following command.
Command
Mode
Description
olt key-exchange start <10-
3600>
GPON-OLT
Starts an encryption key exchange process between
OLT and ONU and specifies an exchange interval.
10-3600: interval for encryption key switchover