Dasan V5808 - Command Line Interface (CLI); Configuration Mode; Privileged EXEC View Mode; Main Command of Privileged EXEC View Mode

UMN:CLI User Manual
V5808
40
3 Command Line Interface (CLI)
The V5808 enables system administrators to manage the V5808 by providing the
command line interface (CLI). This user-friendly CLI provides you with a more convenient
management environment.
To manage the system with the CLI, a management network environment is required. The
V5808 can connect to the management network either directly (outband) or through the
access network (inband). It can even connect using a combination of the two; for example,
a cascaded V5808 connects inband to the cascading switch, and then from the cascading
switch to the management network through the outband interface.
The V5808 also provides the RS232 console interface to simply access the system with a
provided RJ45-to-DB9 cable.
3.1 Configuration Mode
You can configure and manage the V5808 with the CLI via a management network
environment or the console interface.
The CLI provides the following command modes:
• Privileged EXEC View Mode
• Privileged EXEC Enable Mode
• Global Configuration Mode
• Bridge Configuration Mode
• DHCP Pool Configuration Mode
• DHCP Option 82 Configuration Mode
• Interface Configuration Mode
• IP Tunnel Configuration Mode
• Rule Configuration Mode
• RMON Configuration Mode
• Router Configuration Mode
• Route-Map Configuration Mode
• GPON Configuration Mode
3.1.1 Privileged EXEC View Mode
When you log in to the switch, the CLI will start with Privileged EXEC View mode which is
a read-only mode. In this mode, you can see a system configuration and information with
several commands.
Tab. 3.1 shows main command of Privileged EXEC View mode.
Command
Description
enable
Opens Privileged EXEC Enable mode.
exit
Logs out the switch.
show
Shows a system configuration and information.
Tab. 3.1 Main Command of Privileged EXEC View Mode