User Manual UMN:CLI
V5808
749
To configure the filtering for untagged frames, use the following command.
filter ether-type {ipoe | pppoe |
arp | ipv6-ipoe}
Configures the received untagged frames to be filtered
by the provided option.
Deletes the filtering configuration above.
To configure the treatment of filtered untagged frames, use the following command.
treat inner vid <0-4094 cos {<0-
7> | dscp-to-pbit} tpid {output
dei {0 | 1 } | 0x8100}
Configures the inner tag treatment for filtered untagged
frames.
0-4094: uses this value as the VID in the inner VLAN
tag.
0-7: uses this value as the priority in the inner VLAN
tag.
treat outer vid <0-4094> cos {<0-
7> | dscp-to-pbit} tpid {output
dei {0 | 1 } | 0x8100}
Configures the outer tag treatment for filtered untagged
frames.
Drops the filtered untagged frames.
no treat {remove-discard | outer
| inner}
Deletes the treatment-related configuration above.
For untagged frames, queue information need to be specified. You can configure whether
they use a default DSCP to CoS mapping table as specifying the queue (assuming that
the untagged frames can use the DSCP to CoS mapping table). Unless you configure the
table to be used, the untagged frames use default queue information.
To configure to use a default DSCP to CoS mapping table as specifying queue for
untagged frames, use the following command.
dscp-to-cos-map default-map
Configures to use a default DSCP to CoS mapping
table as specifying queue for untagged frames.
Deletes the configuration above.
(= Configures to use default queue information as
specifying queue for untagged frames.)
To Next Page
Loading...