Dasan V5808 - Router Configuration Mode; Route-Map Configuration Mode; Main Command of RMON Configuration Mode; Main Command of Router Configuration Mode

UMN:CLI User Manual
V5808
46
owner
Shows the subject which configures each RMON and uses relevant
information.
Tab. 3.10 Main Command of RMON Configuration Mode
3.1.12 Router Configuration Mode
In Router Configuration mode, you can configure IP routing protocols and VRRP. The
V5808 provides three IP routing protocols such as RIP v2, BGP v4 and OSPF v2.
To open Rule Configuration mode, enter the router command, then the system prompt
will be changed from SWITCH(config)# to SWITCH(config-router)#.
Command
Mode
Description
router {IP-PROTOCOL | vrrp}
Global
Opens Router Configuration mode to configure IP
routing protocols and VRRP.
Tab. 3.11 shows main commands of Router Configuration mode.
Command
Description
distance
Configures distance value to find better route.
neighbor
Configures neighbor router.
network
Configures network to operate each routing protocol.
redistribute
Registers transmitted routing information to another router’s table.
associate
Configures associated IP address same with virtual router.
authentication
Configures password of virtual router group.
preempt
Activates/deactivates preempt.
vr-priority
Assigns priority to virtual router.
vr-timers
Configures advertisement time, which means the interval that master
router distributes its information to another virtual router.
Tab. 3.11 Main Command of Router Configuration Mode
3.1.13 Route-Map Configuration Mode
In Route-map Configuration mode, you can configure to transmit routing information with
various options.
To open Route-map Configuration mode, enter the route-map command, then the
system prompt will be changed from SWITCH(config)# to SWITCH(config-route-map)#.
Command
Mode
Description
route-map NAME {permit | deny}
<1-65535>
Global
Opens Route-map Configuration mode.
Tab. 3.12 shows main commands of Route-map Configuration mode.
Command
Description