Dasan V5808 - Displaying MFIB Information

User Manual UMN:CLI
V5808
485
clear ipv6 mroute * [pim sparse-
mode]
Enable
Global
Deletes all MFC and TIB entries in the PIM-SM
protocol.
clear ipv6 mroute X:X::X:X
[X:X::X:X] [pim sparse-mode]
Deletes a specified MFC and TIB entry in the PIM-SM
protocol.
X:X::X:X: IPv6 source/group address
When clearing the MRIB entries, you must specify the group address prior to the source
address.
10.3.1.6 Displaying MRIB Statistics
To display the multicast routing statistics entries in the MRIB, use the following command.
Command
Mode
Description
show ipv6 mroute count
Enable
Global
Shows all multicast routing statistics entries.
show ipv6 mroute {dense |
sparse} count
Shows the multicast routing statistics entries for a
given PIM mode.
dense: dense mode
sparse: sparse mode
show ipv6 mroute X:X::X:X
[dense | sparse] count
Shows the multicast routing statistics entries for a
given group.
X:X::X:X: group IPv6 address
show ipv6 mroute X:X::X:X
X:X::X:X [dense | sparse] count
Shows the multicast routing statistics entries for a
given group and source.
X:X::X:X: group/source IPv6 address
To delete the multicast routing statistics entries from the multicast routing table, use the
following command.
Command
Mode
Description
clear ipv6 mroute statistics *
Enable
Global
Deletes all multicast routing statistics entries.
clear ipv6 mroute statistics
X:X::X:X [X:X::X:X]
Deletes a specific multicast routing statistics entry.
X:X::X:X: group/source IPv6 address
10.3.1.7 Displaying MFIB Information
The multicast forwarding information base (MFIB) is the group of the information to
forward multicast traffic in Layer 3, which is maintained by currently running multicast
routing protocol. You can verify the forwarding entries in the MFIB with the show ipv6
mfib command.
To display the multicast forwarding entries in the MFIB, use the following command.
Command
Mode
Description
!