Dasan V5808 - ANI RF Video Port Configuration

User Manual UMN:CLI
V5808
661
{enable | disable}
onu uni-description ONU-ID eth
UNI-PORT DESCRIPTION
Adds the description on the specified ONU UNI
Ethernet port.
no onu uni-description ONU-ID
eth UNI-PORT
Deletes the description of the specified ONU UNI
Ethernet port.
To display the status of ONU UNI Ethernet port, use the following command.
Command
Mode
Description
show onu uni-status eth OLT-ID
Enable/Global/GPON
Shows the status of ONU UNI Ethernet port.
show onu uni-status eth [ONU-
IDs]
GPON-OLT
To display the configured description on ONU UNI port, use the following command.
Command
Mode
Description
show onu uni-description OLT-
ID
Enable
Global
GPON
Shows the configured description on ONU UNI port.
show onu uni-description [ONU-
ID]
GPON-OLT
12.2.11.2 ANI RF Video Port Configuration
To configure the ANI RF video port of ONU, use the following command.
Command
Mode
Description
onu port-config ONU-IDs ani
video ANI-PORTs agc
AGC_VALUE
GPON-OLT
Configures the AGC value of ONU ANI RF video port.
ONU-ID: 1-128 or ONU serial number
ANI-PORT: ANI port number
AGC_VALUE: Automatic Gain Control value (-
12.7~12.7 dB)
no onu port-config ONU-IDs ani
video ANI-PORTs agc
Deletes the AGC value of the specified ONU ANI video
port.
To update the system or RF video status of ONU, use the following command.
Command
Mode
Description
onu video-status update {<1-
1440> | disable}
GPON
Sets the ONU’s RF video update
1-1440: update interval time (default: 4 minutes)