Dasan V5808 - Pimv6 Join;Prune Interval; Displaying Pimv6 Information

User Manual UMN:CLI
V5808
491
65535>
1-65535: hello message interval (unit: second)
no ipv6 pim hello-interval
Deletes a specified interval to send PIM hello
messages.
PIM hello messages may contain the hold time value in the option fields, which specifies
how long the information is valid. The default hold time is 3.5 times of the interval of the
PIM hello messages. If you sets 10 seconds, the hold time of the PIM hello message will
be 10 x 3.5 = 35 seconds
If a hold time you specified is less than the current interval of those, the hold time is
ignored and return to the default value.
To specify a hold time of PIM hello messages, use the following command.
Command
Mode
Description
ipv6 pim hello-holdtime
<1-65535>
Interface
Specifies a hold time of PIM hello messages.
1-65535: hello message hold time (unit: second)
no ipv6 pim hello-holdtime
Deletes a specified hold time of PIM hello messages.
10.3.2.5 PIMv6 Join/Prune Interval
Router sends the PIM join/prune message to the upstream RPF neighbor. PIM multicast
traffic can join or be removed from the shortest path tree (SPT) or rendezvous point tree
(RPT).
To specify an interval to send PIM join/prune messages, use the following command.
Command
Mode
Description
ipv6 pim jp-timer <1-65535>
Global
Specifies an interval to send join/prune messages.
1-65535: join/prune message interval (unit: second)
no ipv6 pim jp-timer [<1-65535>]
Deletes a specified interval to send join/prune
messages.
10.3.2.6 Displaying PIMv6 Information
To display current PIM information, use the following command.
Command
Mode
Description
show debugging ipv6 pim
sparse-mode
Enable/
Global/
Bridge
Shows PIM-SMv6 debugging status
show ipv6 pim interface [detail]
Enable
Global
Shows PIMv6 interface information.
detail: detailed interface information
!