UMN:CLI User Manual
V5808
94
4.6.1.4 Authentication Port
After configuring 802.1x authentication mode, you should select the authentication port.
Designates 802.1x authentication port.
Disables 802.1x authentication port.
4.6.1.5 Force Authorization
The V5808 can permit the users requesting the access regardless of the authentication
from RADIUS server. For example, even though a client is authenticated from the server,
it is possible to configure not to be authenticated from the server.
To manage the approval for the designated port, use the following command.
dot1x port-control {auto | force-
authorized | force-unauthorized}
PORTS
Configures a state of the authentication port.
auto: authorization up to RADIUS server (default)
force-authorized: force authorization
force-unauthorized: force unauthorization
no dot1x port-control PORTS
Deletes a configured authentication port state.
4.6.1.6 Interval for Retransmitting Request/Identity Packet
In the V5808, it is possible to specify how long the device waits for a client to send back a
response/identity packet after the device has sent a request/identity packet. If the client
does not send back a response/identity packet during this time, the device retransmits the
request/identity packet.
To configure the number of seconds that the switch waits for a response to a
request/identity packet, use the following command.
dot1x timeout tx-period <1-
65535> PORTS
Sets reattempt interval for requesting request/identity
packet.
1-65535: retransmit interval (default: 30)
no dot1x timeout tx-period
PORTS
Disables the interval for requesting identity.
4.6.1.7 Interval of Authentication
To configure a term of authentication, use the following command.
dot1x timeout auth-period <1-
4294967295>
Sets the period between authentication attempts.
no dot1x timeout auth-period
Deletes the period between authentication attempts.
To Next Page
Loading...