Dasan V5808 User Manual

UMN:CLI User Manual
V5808
788
To modify an existing multicast access list, use the following command.
Command
Mode
Description
multicast-access-list NAME
modify
GPON
Modifies the existing multicast access list.
NAME: multicast access list name
12.11.6.2 IGMP Access List Configuration
To configure the multicast access list, use the following command.
Command
Mode
Description
igmp access-list vid {untagged |
VLAN} dst-ip start A.B.C.D end
A.B.C.D [bw VALUE | src-ip
A.B.C.D | gem PORT | cos <0-7>]
Multicast-
ACL
Configures the dynamic/static access control list table.
It discards the IGMP join message from ONTs based
on the access list.
VLAN: 1 to 4095, VLAN ID for specific tagged
downstream flow
dst-ip: destination IP address
A.B.C.D: start/end IP address of the multicast group
range
VALUE: imputed group bandwidth (unit: bytes/sec)
src-ip: source IP address
PORT: multicast GEM port ID
igmp static-access-list vid
{untagged | VLAN} dst-ip start
A.B.C.D end A.B.C.D [bw VALUE
| src-ip A.B.C.D | gem PORT |
cos <0-7>]
To remove the dynamic/static access control list configuration from the multicast access
list, use the following command.
Command
Mode
Description
no igmp {access-list | static-access-list} all
Multicast-
ACL
Removes the dynamic/static access
control list configuration from the
multicast access list.
no igmp access-list vid {untagged | VLANS}
dst-ip start A.B.C.D end A.B.C.D [bw VALUE |
src-ip A.B.C.D | gem PORTS]
no igmp static-access-list vid {untagged |
VLANS} dst-ip start A.B.C.D end A.B.C.D [bw
VALUE | src-ip A.B.C.D | gem PORTS]
12.11.6.3 Saving Multicast ACL
After configuring a multicast ACL, you need to save the profile with the following
command.
Command
Mode
Description
apply
Multicast-
ACL
Saves a multicast ACL configuration.
Whenever you modify a multicast ACL, you should apply the changes again using the
apply command. If you do not, it will not be applied.
i

Dasan V5808 Specifications

General

Brand	Dasan
Model	V5808
Category	Network Router
Language	English