User Manual UMN:CLI
V5808
647
12.2 ONU Management
This section describes how to manage an ONU (ONT). The V5808 provides the
centralized remote ONU (ONT) management concept, so you can manage every remote
ONU (ONT) connected to the V5808 without any local configuration for the ONUs (ONTs).
12.2.1 ONU Registration
The default ONU (ONT) registration mode is the auto mode in which an OLT registers
ONUs automatically, when receiving the serial number from the ONU. For an optimized
ONU configuration, however, the manual mode is recommended. Some options are only
available in the manual mode.
The V5808 is able to register ONU (ONT) automatically and manually.
• By default, the V5808 registers ONUs automatically when the ONU is connected
through its serial number registration. In this case, ONU ID is also given.
• Administrator can register specific ONUs (ONTs) manually with MAC address or se-
rial number.
12.2.1.1 Activating/deactivating ONU
To activate/deactivate the ONU(ONT), use the following command.
Activates the specified ONU ID.
Deactivates the specified ONU ID.
12.2.1.2 ONU Registration Method
There are several methods to register an ONU. You use a different method to recognize
an existing ONU during subsequent activations. For example, authenticating a newly
activated ONU by serial number allows for increased security during normal operation,
whereas authenticating an ONU by registration ID (PLOAM password) allows for flexibility
during installation and repair.
To specify the ONU registration method, use the following command.
onu activation-mode serial-
number
Configures the ONU’s serial-number based registration
mode. (default)
onu activation-mode
registration-id
Configures the ONU’s registration ID based registration
mode.
Configures the ONU’s logical ONU identification based
registration mode.
You should remove all ONU database before changing the ONU registration method.
To Next Page
Loading...