User Manual UMN:CLI
V5808
67
System rebooting wipes all the existing configurations. To save the configurations before
the rebooting, answer “y” to the question Do you want to save the system configuration?
[y/n]. If you answer “n” by misoperation, answer “n” to the next question Do you want to
reload the system? [y/n] to cancel the rebooting and start the operation all over again.
The following is an example of restarting the system with the reload command.
SWITCH(enable)# reload
Do you want to save the system configuration? [y/n]
Do you want to reload the system? [y/n]
4.1.11.2 System Rebooting Scheduler
The reload command in Privileged EXEC Eable Configuration mode immediately reboots
the system. Using reload at/in command in Global Configuration mode, you can
schedule a rebooting time for any reason.
To set the system reloading scheduler, use the following command.
reload at HH:MM DAY MONTH
YEAR
Restarts the system at the specified exact time.
Restarts the system everyday at the same time.
Restarts the system when the specified time period is
over.
To cancel the reload previously scheduled, use the following command.
Deletes the whole system rebooting schedule settings.
no reload at [HH:MM DAY
MONTH YEAR]
Cancels the specified reload time, day and month.
no reload at HH:MM in daily
Cancels the specified time (hour, minutes) for reloading
everyday.
Deletes the specified period for the reload.
To display the reload scheduler, use the following command.
Displays the reload scheduler.
To Next Page
Loading...