Dasan V5808 - System Threshold; Port Traffic

User Manual UMN:CLI
V5808
117
This configuration is also applicable to a TFTP client.
6.1.13 System Threshold
You can configure the system with various kinds of the system threshold such as CPU
load, traffic, temperature, etc. Using this threshold, the V5808 generates syslog
messages, sends SNMP traps, or performs a relevant procedure.
6.1.13.1 CPU Load
To set the threshold of CPU load, use the following command.
Command
Mode
Description
threshold cpu <21-100> {5 | 60 |
600} [<20-100> {5 | 60 | 600}]
Global
Sets the threshold of CPU load in the unit of percent
(%).
21-100: CPU load high (default: 50)
20-100: CPU load low
5 | 60 | 600: time interval (unit: second)
no threshold cpu
Deletes the configured threshold of CPU load.
To display the configured threshold of CPU load, use the following command.
Command
Mode
Description
show cpuload
Enable
Global
Bridge
Shows the configured threshold and average of CPU
load.
show cpu-trueload
Shows the CPU load during the last 10 minutes in the
time slots of every 5 seconds.
6.1.13.2 Port Traffic
To set the threshold of port traffic, use the following command.
Command
Mode
Description
threshold port PORTS
THRESHOLD {5 | 60 | 600} {rx |
tx}
Global
Sets the threshold of port traffic.
PORTS: port number
THRESHOLD: threshold value (unit: kbps)
5 | 60 | 600: time interval (unit: second)
no threshold port PORTS {rx |
tx}
Deletes the configured threshold of port traffic.
The threshold of the port is set to the maximum rate of the port by default.
i
i