Dasan V5808 - Network Dial Plan; To Configure a Release Timer; To Configure a ROH Timer; To Configure the Critical Dial Timeout

UMN:CLI User Manual
V5808
764
To configure a release timer, use the following command.
Command
Mode
Description
release-timer <0-255>
VoIP-SIP
Configures a release timer. The value 0 specifies that
the ONT is to use its internal default. (unit: second,
default: 10)
To configure a ROH timer, use the following command.
Command
Mode
Description
roh-timer <0-255>
VoIP-SIP
Defines the time for the receiver off hook condition
before ROH tone is applied. The value 0 disables ROH
timing. (unit: second, default: 15)
12.7.2.6 Network Dial Plan
To configure the critical dial timeout, use the following command.
Command
Mode
Description
dial-plan crit-timeout TIMEOUT
VoIP-SIP
Defines the critical dial timeout for digit map
processing.
TIMEOUT: critical dial timeout (unit: ms, default: 4000)
To configure the partial dial timeout, use the following command.
Command
Mode
Description
dial-plan part-timeout TIMEOUT
VoIP-SIP
Defines the partial dial timeout for digit map
processing.
TIMEOUT: partial dial timeout (unit: ms, default: 16000)
To configure the dial plan format, use the following command.
Command
Mode
Description
dial-plan format {h248 | nsc |
vendor}
VoIP-SIP
Defines the dial plan format standard that is supported
in the ONT for VoIP.
h248: H.248 format with specific plan (table entries
define the dialling plan)
nsc: NSC format
vendor: vendor-specific format
To configure the dial plan table, use the following command.
Command
Mode
Description
dial-plan table TABLE_ID
TABLE_TOKEN
VoIP-SIP
Adds a dial plan with the configured token.
TABLE_ID: A unique identifier of a dial plan within the
dial plan table