User Manual UMN:CLI
V5808
377
8.7.1 Configuring VRRP
To configure the V5808 as device in Virtual Router, use the following command on Global
Configuration mode. Then you can configure VRRP by opening VRRP Configuration
mode.
router vrrp INTERFACE GROUP-
ID
Configures Virtual Router (VRRP Group).
GROUP-ID: 1-255
To delete the VRRP configuration, use the following command.
no router vrrp {<1-255> | all}
Configures Virtual Router (VRRP Group).
1-255: VRRP virtual server ID
8.7.1.1 Associated IP Address
After configuring a virtual router, you need to assign an associated IP address to the
virtual router. Assign unified IP address to routers in one group.
To assign an associate IP address to routers to a virtual router or delete a configured
associate IP address, use the following command.
Assigns an associated IP address to a virtual router.
A.B.C.D: virtual router IP address
no associate {A.B.C.D | all}
Deletes an assigned associated IP address from a
virtual router.
8.7.1.2 Access to Associated IP Address
If you configure the function of accessing Associated IP address, you can access to
Associated IP address by the commands such as ping.
To configure the function of accessing Associated IP address, use the following command.
Enables the function of accessing associated IP
address.
Disables the function of accessing associated IP
address.
8.7.1.3 Master Router and Backup Router
The V5808 can be configured as Master Router and Backup Router by comparing Priority
and IP address of devices in Virtual Router. First of all, it compares Priority. A device,
which has higher Priority, is to be higher precedence. And when devices have same
Priority, then it compares IP address. A device, which has higher IP address, is to be
To Next Page
Loading...